57
Setting
Timer left before Lamp is
off
.
Power management
For reducing power consumption as well as maintaining
the lamp life, the Power management function turns off the
projection lamp when the projector is not operated for a
certain period.
Select one of the following options:
Ready
.................. When the lamp has been fully cooled
down, the POWER indicator changes
to green blinking. In this condition, the
projection lamp will be turned on if the
input signal is reconnected or any button
on the remote control is pressed.
Shut down
.......... When the lamp has been fully cooled
down, the power will be turned off.
Off
....................... Power management function is off.
Timer
................... If the input signal is interrupted and
no button is pressed for more than
30 seconds, the timer display with
No
signal
appears. It starts the countdown
until the lamp is turned off. Use the Point
54
buttons to set the Timer(1~30Min).
Note:
Factory default is
Ready: 5 Min
.
When this function is set to
On
, the projector will be
automatically turned on just by connecting the AC power
cord to a wall outlet.
Note:
Be sure to turn off the projector properly (see “Turning Off
the Projector” on page 22). If the projector is turned off in
the incorrect sequence, the Direct on function does not
work properly.
Direct on
Power management
Содержание PDG-DXL2000 - 2000 Lumens
