Sanyo PDG-DSU30 - 2500, Руководство пользователя

Страница: 47 / 51

46
English
Appendices
Operation
1. Connect the specified RS-232C control cable to SERVICE PORT on
the projector and serial port on the PC.
2. Launch a communication software provided with PC and setup the
communication condition as follows:
3. Type the command for controlling the projector and then enter the
“Enter” key.
Example
When you want to change the input to Computer
, Type ‘C’ ‘0’ ‘5’
‘Enter’.
Serial Control Interface
This projector provides a function to control and monitor the
projector’s operations by using the RS-232C serial port.
Baud rate : 9600 bps
Parity check: : none
Stop bit : 1
Flow control : none
Data bit : 8
• The default of the baud rate is set to 9600 bps. If an error occurs in the com -
munication, change the serial port.
• Enter with ASCII 64-byte capital characters and one-byte characters.
Note
ORDER RS-232C CONTROL CABLE
RS-232C control cable can be ordered through your dealer. When order-
ing, give the following information to the dealer.
■ Model No. of your projector : PDG-DSU30
■ RS-232C control cable : Service parts No. CH4200272G002