RLM-W12
Quick start guide
Call for support: USA
+
1 866 374 7878
EMEA
+32 56 368609
APAC
+86 400 88 22726
Mounting the lens
LED indication chart
Removal of lens protection sponge.
Slide lens in (motor connector on up side).
Make sure that motor connector is fully
connected.
Make sure lens is locked firmly.
Move the lens clip up ward.
IMPORTANT:
•
Remove the lens before transporting the projector.
•
To save lamp lifetime, first switch the projector to
standby mode and wait two minutes, then switch
off the main power.
•
Ensure that the projector is operating with clean
filters.
•
Do not block the ventilation in and outlets
•
Using the projector in a non recommended tilt
angle will reduce the lifetime of the lamps or
create unexpected behavior of the unit.
•
Laser light can cause severe damage to the DMD.
This damage is not covered by warranty.
Aft
er
fact
ory
rese
t
the projectors needs some time to scan the
inputs before displaying the source.
Au
t
o sou
rce
can be switched off in the CONTROL menu. The
manual selection can be done via menu or other control sys-
tems.
C
onfigu
ration
of the unit is set as standard in table front
projection mode. Change the projector set up in the CONFIGURA-
TION menu.
If geom
e
trical di
st
ortion o
cc
urs
(H/V keystone), this can be
corrected with Keystone in the CONFIGURATION menu.
T
uning the image
can be done in the IMAGE menu. Default
values are 100.
Pictu
re
-in-Pictu
r
e
control
can be done in the LAYOUT menu.
Lamp
management in the LAMP menu.
Swit
ching
off
the unit can be done by pressing the STBY
button for 2 sec. or the O button for 2 sec. on the remote
control.
13
14
15
16
17
10
11
12
Quick setup and operation
The following summarizes RLM-W12 setup and operation. For error-
free installation always refer to the listed section in the User Guide.
C
onnect p
ower.
Select the correct voltage (110V or 220V)
C
onnect
av
ailable sou
rces
to the appropriate input terminal.
Pow
er on.
Turn the mains switch to on.
Stan
d
b
y LED
(blue) must be constantly lit.
S
tart up
the unit by pressing the STBY button.
W
arm up
of the unit takes approx. 45 sec till image appears.
Image
of the source should appear after 15 seconds if the unit
is in full auto mode.
A
dju
s
t the lens s
ettings
by pressing the ENTER button for
ZOOM and FOCUS adjust. Toggle to SHIFT by pressing ENTER
again. Lens function can also be found in the CONFIGURATION
menu.
Fact
ory
Reset
can be executed in order to put the unit in the
full auto mode. Factory reset can be found in the SERVICE menu.
Press execute and wait 30 sec.
1
2
3
4
5
6
7
8
9
Blue
(STANDBY)
Green
(ON)
R
ed
(ERROR)
Standby
Cooling / Warm up
Power on / Normal
Lamp failure
Lamp door open
Fan failure
Overheating
System error
-
-
-
-
Printed on FSC certified paper (www.fsc.org)
RLM-W12 Quickstart guide
according to the area it is used before turn on the power.
confirm
configurations.
configure
