Sanyo FW50C36F, Руководство пользователя

Страница: 19 / 57

3 Use your TV
Switching on your TV and putting it in
standby mode
Remote control
TV
To turn the TV on from standby or off to standby
●
Press B on the TV or the remote control.
Note(s)
●
Energy consumption contributes to air and water pollution. When the AC power cord is
plugged in, your TV consumes energy with a very low standby power consumption.
Adjusting volume
Remote control
TV
To decrease or increase volume
●
Press VOL J / K on the TV or press VOL + / – on the remote control.
VOL J (–) : Volume down
VOL K (+) : Volume up
To mute or unmute sound
●
Press D on the remote control to mute the sound.
●
Press D again or VOL + / – to recover the original sound.
Switching channels
TV
Remote control
To select channels by using CH
H
/
I
or CH + / –
●
Press CH H (up) / I
（
down) on the TV or press CH + / – on the remote
control.
To select channels by using the NUMBER buttons
Digital TV operation
●
For digital channels, press a number followed by a dot “
•
” and the
corresponding sub channel number.
–
When selecting digital channel 11.1
Be sure to press • before entering the subchannel number.
Cable / NTSC (Analog) TV operation
–
When selecting cable or analog channel 11
Press PREV.CH to return to the previously viewed channel.
Note(s)
●
To select the non-memorized channels, use the NUMBER buttons .
●
Channel not available or No signal will appear on the TV screen after the subchannel
broadcast is over.
●
Audio only
message will appear on the TV screen, when you receive only sound signal.
19 .
English
Continued on next page.