B. REMOVING PRIMARY INTERLOCK SWITCH
AND INTERLOCK MONITOR SWITCH
(Figure 11-b)
(1) Disconnect all wire leads from Primary Interlock and
Interlock Monitor Switch.
(2) Pull the Primary Interlock Switch or Interlock Monitor
Switch upward at the same time while pushing the
switch stoppers to allow a space between the
switch body and catches.
(3) Make necessary adjustments or replacement of
switch by the reversing step (2) and check micro-
wave energy leakage according to “
1. ADJUSTMENT
PROCEDURES
” on page 1, after it is replaced with
new one, and check proper operation of it according
to “
CHECKOUT PROCEDURE FOR SWITCHES
”
on page 6.
Interlock Switch Replacement - when replacing
faulty switches, be sure switch mounting tabs are
not bent, broken or otherwise deficient in their
ability to secure the switches in place.
7. DISASSEMBLY INSTRUCTIONS
• OVEN MUST BE DISCONNECTED FROM ELECTRICAL
OUTLET WHEN MAKING REPLACEMENTS, REPAIRS,
ADJUSTMENTS AND CONTINUITY CHECKS BEFORE
PROCEEDING WITH ANY REPAIR WORK. AFTER
DISCONNECTING, WAIT AT LEAST 1 MINUTE, UNTIL
THE CAPACITOR IN THE HIGH-VOLTAGE AREA
HAS FULLY DISCHARGED.
• WHEN REPLACING ANY DOOR MICROSWITCH,
REPLACE WITH THE SAME TYPE SWITCH SPECIFIED
ON THE PARTS LIST.
A. REMOVING DOOR SENSING SWITCH
(Figures 1 on page 1, 11-a)
(1) Disconnect all wire leads from the Door Sensing
Switch. (Figure 1 on page 1)
(2) Remove 2 screws securing the Lever Stopper.
(3) Push the Door Sensing Switch upward while pressing
adjacent upper switch stopper of Lever Stopper and
lower switch stopper down (Figure 11-a).
(4) Then remove it by lightly pressing the switch toward
you (Figure 11-a).
(5) Make necessary adjustments or replacements of the
Door Sensing Switch by reversing step (3) and check
microwave energy leakage according to
“
1. ADJUSTMENT PROCEDURES
” on page 1, after it
is replaced with new one, and check proper operation
of it according to “
CHECKOUT PROCEDURE FOR
SWITCHES
” on page 6.
- 11 -
Primary
Interlock
Switch
Interlock
Monitor
Switch
Switch Stoppers
Figure 11-b
Switch Stoppers
Lower
Switch
Stopper
Door
Sensing
Switch
Upper
Switch
Stopper
Figure 11-a
Содержание EM-V3410WS
Страница 20: ... 19 CONTROL CIRCUIT BOARD Part No 617 237 4116 47100 ...
Страница 22: ... 21 9 OVERALL CIRCUIT DIAGRAM ...
Страница 23: ......
Страница 24: ...FEBRUARY 2001 Printed in Singapore SANYO Electric Co Ltd Osaka Japan ...