6
Battery setup
1. Remove the battery compartment
cover on the handset, insert the
battery, plug the cord into the jack
(inside the compartment) and replace
the cover.
2. Set the handset
RINGER
switch to
ON
, and place handset in the base.
3. Plug the AC adaptor into the
Power
DC 9V
jack on the back of the base.
Plug the other end into an electrical
outlet. The CHARGE/IN USE
indicator comes on verifying that the
battery is charging. Charge the
handset for 12 continuous hours
prior to first use. The initial battery
charge is important for best
performance.
Note:
It is normal for the handset and
base to get warm when the handset
is charging in the base.
Caution:
Use only the Sanyo AC adaptor that is supplied with this
phone. Using another AC adaptor may damage the phone.
Telephone line connection
4. Plug the telephone line cord into the
TEL LINE
jack
on the back of the base. Plug the other end into a
modular phone jack.
5. Wrap the cords through the brackets provided to
ensure the base stands flat.
Tone/pulse setting
6. If you have Pulse (rotary) service, you will need to set the dial mode
to pulse. If you have Touch-Tone service, do nothing as your phone
has been set to Tone prior to shipment. If you do not know which
type of service you have, contact your local telephone company.
7. To change to Pulse or Tone service, See
Tone/pulse setting
,
page 10.
GETTING STARTED
1. Slide down the
battery cover
2. Place the batteries
in the slot
3. Plug the wire into
the jack
4. Slide up the battery
cover