3030 Corporate Grove Dr • Hudsonville • MI • 49426
Phone: 616-396-1355 • www.itc-us.com • [email protected] • DOC#: 710-00210 Rev A • 02/15/22
Rotating Phone Holder Install Instructions
(Part #’s: PH01-XBK)
Safety/Installation Considerations
• Disconnect power before installing, adding or changing any component.
• To avoid a hazard to children, account for all parts and destroy all packing materials.
•
Electrical Specs:
Input voltage: 10-30V DC| Input Current: Wireless: 1A | USB-A: 1.9A | USB-C: 2.4A
Charging Capacity: Wireless Only: 10W | Wi USB-A: 10W + 12W | Wi USB-C: 10W + 18W
• Positive (+) outputs require a fuse if the attached wire leads are not rated to handle the max current.
• The charger has been designed to work with Qi compatible devices.
•
The charger has been designed to charge and operate within the receiving device’s thermal parameters.
Low or high temperatures might cause the receiving device to change their charging behavior to regulate its
temperature and preserve battery life. Typical temperature ranges are 0ºC to 35ºC (32ºF to 95ºF). When
exceeding these operating temperatures, the phone and/or the charging device may temporarily stop
charging to protect from overheating.
• The wireless charging module has been designed to be optimized with no case installed. If a thick phone
case is added to the distance between the charger surface and the phone it may cause the device to not
charge or to temporarily shut down to protect from over-heating.
For warranty information please visit www.itc-us.com
PARTS / TOOLS NEEDED:
Phone Holder
#6 Pan Head Mounting Screws
(not provided)
Power Drill & Hole Saw
Marine Grade Splices
(not provided)
1.
Determine the installation location and mark the mounting holes.
Pre-drill the mounting holes and drill a 1⅜” hole for the wire access.
