Sanyo ASW U1100T, Руководство по обслуживанию

Страница: 7 / 29

- 6 -
7. Operation of fully Automatic Washing program
NORMAL, HEAVY DUTY, CUSTOM, SOAK Course:
Turn on the power switch (ON/ OFF)
Load the laundry into the washer
Press the ONE TOUCH SELECT to select the washing course
Press the START/ PAUSE button
The washer begins rotating the Pulsator right then left two times
to check the volume of the laundry and select the most suitable
water level.
Water is supplied to the lowest water level LOW2.
The Pulsator rotates right and left in about 40 , in that time
sensor will determine type of fabric and select the most suitable
program, such as: Spinning time, Washing time, Rinsing mode,
water flow
Water is supplied to the selected water level.
In Soak course, the laundry is soaked for 45 minutes. During the
soaking, Pulsator will rotate intermittently 5 minutes per cycle to
stir the laundry.
Within 40 seconds from washing process, Pulsator rotates to
create flow water to confirm water level.
40 seconds after starting washing, Pulsator stops in 4 seconds to
check the water level, if the water level is lower, the program will
automatically supply the water until the selected water level is
reached
1 minute after starting washing process, sensor will receive the
signals from revolution of laundry. Responding to the revolution
of laundry, microchip will determine the most suitable water
flows.
1 before completion of washing process, Pulsator will rotate to
create laundry disentanglement flow water.
After water level reaches reset point, draining course continues
for 1 40 .
In the first spinning, washer carries out 1 10 ON intermittent spin
dry cycle.
Before completion of spinning, electrical continuity of motor
breaks off and motor rotates continuously by inertia. The Brake
Ass y activates while Spin Tub revolution speed is slowing down.
During Spinning: If the clothes clump on one side or the Spin Tub
becomes unbalanced, the microchip will detect the unbalance
condition and automatically proceed the following corrective.
Water is supplied to the selected water level.
Water save rinse: Water is supplied to the selected water level
responding to the wash load, Pulsator rotates and water
supplying is stopped.
Overflow rinse: After water is supplied to the selected water level,
Pulsator rotates and water is continuously supplied.
PULSATOR ROTATES
WATER IS SUPPLIED
PULSATOR ROTATES
WATER IS SUPPLIED
SOAK
WASH
WATER IS SUPPLIED
WASH
DRAIN
SPIN
WATER IS SUPPLIED
RINSE
After 40
RINSE
WASH