Sanyo Denki A11F102 Series, Руководство пользователя

Страница: 6 / 11

- 4 -
(5) Connect the Contact Signal Interface Card and the UPS using the accessory
cable
Use the communication cable to connect the “CARD I/F” connector of the
UPS and the “AUX IN” connector of the Contact Signal Interface Card as
shown in the Fig.3-3.
Fig. 3-3 Connection to the UPS using the communication cable (UPS rear panel)
(6) Connect the computer and the Contact Signal Interface Card using the
signal cable
Use the special signal cable to connect the “CONTACTS SIGNAL” TERMINAL
BLOCKS of the Contact Signal Interface Card to the computer.
Contact Signal
Interface Card
AUX IN
UPS
CARD
I/F
Computer
(Load devices)
Connect with the signal cable
Communication cable
(Accessory)
When the UPS is E11A series, Installation of the Contact Signal
Interface Card and the UPS setting procedures are now complete.
Start the UPS according to the procedures in the UPS Instruction Manual.
Even if interface setteing of E11A is set to “Workstation mode” or to
“Standalone mode”, UPS works.
In addition, you cannot use the Contact Signal Interface Card and the LAN
Interface Card at the same time.
In the case of E11A, only TYPE C can be connected to this CARD.