SANY SY500H, Руководство по эксплуатации и обслуживанию

Страница: 25 / 196

SAFETY
2-3 SY500H Excavator OMM
Mount and Dismount the
Machine
0000635
Figure 2-1
Mounting or dismounting the machine presents hazards.
Observe the following:
• Always make sure the hydraulic lockout control lever
is in the locked (closed) position before entering or
exiting the machine.
• Always make sure the machine is at a full stop
before entering or exiting the machine. Never jump
on or off the machine.
• Never exit or enter the cab by any means other than
the provided grab handles and steps.
• Always face the machine as you mount and
dismount.
• Always maintain three-point contact (both feet and
one hand, or one foot and both hands) with the grab
handles, steps, and deck for proper support.
• Wear safety shoes with slip-resistant soles.
• Do not walk on any surface of the machine if its
slip-resistant material is missing or excessively
worn. Do not step on surfaces of the machine that
are not approved for walking or working. Keep all
walking and working surfaces of the machine clean,
dry, and slip-resistant.
• Always keep grab handles, steps, and walkway
areas clean and clear of mud, oil, grease, or similar
debris. If these areas are damaged, have them
repaired or replaced immediately.
Machine Safety
Authorized Use of This Machine
This excavator is a multipurpose construction machine
used primarily for digging or loading earth and stones. It
can also be used for lifting, breaking, demolishing, and
trenching. It can perform the functions of a loader and a
crane.
SANY assumes no responsibility for any consequence
caused by use outside this specified range.
Unauthorized Use of This Machine
Unauthorized uses include, but are not limited to, the
following:
• Transporting riders on the machine or in the cab.
• Towing or pushing other equipment.
Unauthorized Machine Modifications
Do not perform any unauthorized machine modifications.
Do not add additional weight (attachments, etc.) to the
machine. Do not exceed the gross weight.
Escape Tool
NOTE: Inspect the escape tool periodically. Replace the
escape tool if it appears damaged or unable to
break a cab window for an emergency exit.
As a precaution, keep an escape tool in the cab.
Fire Safety
Fuel, oil, and some engine coolants are flammable.
Observe the following:
• Keep open flames, airborne sparks, and burning
embers away from the machine.
• Shut down the engine and do not smoke when
refueling or servicing the machine.
• Add oil, fuel, or coolant in a well-ventilated area.
• Clean up any spilled fluids immediately.
• Check the machine daily for debris buildup.
Electrical Fires
Short circuits, damaged wiring, or overcharging batteries
can cause fires. Observe the following:
• Check the wiring on the machine for damage when
doing a prestart check. Contact a SANY dealer to
repair or replace any damaged wiring.
• Make sure the battery is operating in its
recommended range.
• Never install aftermarket electrical equipment
without approval from a SANY dealer.