SANY SY500H, Руководство по эксплуатации и обслуживанию

Страница: 168 / 196

5-60
MAINTENANCE
SY500H Excavator OMM
Figure 5-8
WARNING
Keep any belt slack to no more than 1 in. (25 mm).
Belt slack beyond this amount could significantly
reduce protection in an accident, which could
result in death or serious injury.
3. Make sure the belt releases when the red button (4)
is pressed at the end of the buckle (5).
WARNING
Contact a SANY dealer if the seat belt fails any of
these checks or fails to fasten or unfasten, which
could result in death or serious injury.
Check the Sheet Metal
NOTE: Repair or replace sheet metal parts as needed
using SANY-approved parts.
Check all the sheet metal panels and covers for loss,
damage, loose connections, or missing fasteners.
Structural Inspection
1. Thoroughly wash the machine.
2. Inspect the entire structure of the machine for signs
of damage or excessive wear.
Clean and Check the Upper Structure and
Undercarriage
The machine consists of two major component groups:
• The undercarriage with its various components and
assemblies
• The upper structure with its various components and
assemblies
1. Thoroughly clean the machine.
2. Check all structural components for cracks or
distortion.
Check the Windshield Washer Fluid
1. Check the washer fluid level inside the windshield
washer tank, behind the left front access door.
0004784
Figure 5-9
NOTE: Use washer fluid appropriate for use in very cold
or winter climates as required.
2. Remove the cap (1) and add windshield washer fluid
if fluid is required.
0000828
5
4
1