Sanwa DCL1000, Инструкция по эксплуатации, Страница: 5 / 23

— 2 —
5. Never use the meter near equipment which generates strong
electromagnetic waves or is charged.
6. Never use the meter if the meter or test leads are damaged
or broken.
7. Never use the meter with the case or battery lid removed.
8. During measurement, do not hold a place beyond the barrier
of the meter or the test pin side of the flange of the test
leads.
9. To measure a voltage, first connect the black test lead to the
negative (-) or ground side. When disconnecting, the
positive (+) or non-ground side must be disconnected last.
10.During measurement, do not change the meter to another
function.
11.Before starting measurement, make sure that the function
and range are properly set.
12.Never use the meter when it is wet or with wet hands.
13.Be sure to use the specified type of test leads.
14.Never attempt repair or modification, except for battery
replacement.
15.Inspect the meter at least once a year.
16.This meter is for indoor use only.
1-3 Overload Protection
The maximum rated input value and overload protection have
been established for the signal input part of each function.
DC ･ AC 600V
Function Signal Input Part Maximum Rated Input Value Maximum Overload Protection
AC 1000Arms
DC
･
AC 600V
AC 1000Arms
Voltage and current
input prohibited.
Clamp type current
sensor （ CT ）
B
and - terminal
DCL1000_英本文_三 06.4.14 6:54 PM ページ 2