Sanuvox Bio-Wall MAX, Инструкция по эксплуатации

Страница: 14 / 16

14
Instruction Manual for BIO-WALL™
1-888-726-8869 www.sanuvox.com
How to Clean your Product
For optimum performance, lamps should be protected from dust and residue. Since the lamps are installed in the direction of
the air flow, it is unlikely that they will accumulate dust. Nevertheless we suggest to check their fouling if possible after 6 months.
Clean the lamps and their reflectors as needed with mild soap or isopropyl alcohol. Use a rag. Always test the cleaner to make
sure it does not damage the surface.
CAUTION: Under no circumstance should water be sprayed or splashed onto the product.
STORAGE
The BIO-WALL™ does not require specific storage. It is a permanent unit that works continuously when powered.
CAUTION: Keep away from unsupervised children. This unit is not a toy.
ULTRAVIOLETS: UVC
The UVC (254 nm) wavelengths produced by Sanuvox UV units and systems are the same as the ultraviolets produced by the
Sun. The UVC attacks the micro-organisms on a molecular level deactivating the contaminants. Unlike conventional UV lamps
on the market, Sanuvox UV units and systems use a patented process designed to deliver the maximum UV dosage to the
moving airstream or surface.
CAUTION: Never expose eyes or skin to an operating UV lamp.
ELECTRICAL RATINGS, POWER CONSUMPTION & AVAILABLE VOLTAGE
The BIO-WALL™ in its largest configuration has a power consumption of up to 775 W each.
The BIO-WALL™ necessary power requirements is 115-277 VAC, 50/60Hz.
The BIO-WALL™ requires a dedicated circuit breaker with a minimum rating of 10A.
The door switch must operate on 5 VDC.
See product label to confirm power consumption of your specific unit or system.
NOTE: IF YOU EXPERIENCE A PROBLEM, PLEASE CONTACT CUSTOMER SERVICE FIRST OR SEE YOUR WARRANTY.
DO NOT RETURN THE PRODUCT TO THE ORIGINAL PLACE OF PURCHASE. DO NOT ATTEMPT TO OPEN THE
PRODUCT OR TAMPER WITH ITS COMPONENTS WITHOUT CONTACTING CUSTOMER SERVICE FIRST. DOING SO
MAY VOID YOUR WARRANTY AND CAUSE PERSONAL INJURY OR DAMAGE TO THE PRODUCT.
Step by Step Lamp Timer Reset
STEP 1
1. Press and hold the Mode button until the LEDs flash RED, then turn
GREEN.
2. The countdown of all lamps is reset to 17000 hrs.