User manual SanStore-4EM / SanStore-8EM
_________________________________________________________________________________
- 35 -
6.6.2 Alarm setup
ITEM
ADJUSTMENT
RECORD TIME
Determines the duration of the recording after the alarm signal has been
activated.
[10 sec. - 300 sec]
RECORD CAMERA
„ALL”: Start to record all alarm “ON” channels if there is any alarm signal
triggered.
„1:1”: Start to record the channel on which the alarm is triggered.
MOTION TO ALARM
Select “ON” to use the motion detection if analarm is triggered
- In the log, it will be listed as motion.
- An e-mail is not sent.
ALARM BUZZER
ON: The buzzer sounds if an alarm is triggered. The buzzer will sound for the
duration of the recording time..
OFF
:
Disables the alarm buzzer function.
Note:
Press the [ - ] button to stop the buzzer immediately. Stopping the buzzer
doesn’t stop the alarm recording.
ALARM OUT 1 / 2
Configure which relay will be triggered when an alarm is activated per
camera. Select from four available options:
“Alarm in 1”, “Alarm in 2”, Alarm in 3”, “Alarm in 4” and “System”.
Note:
If “System” is selected, the relay will be triggered when the system
experiences problems such as HDD fail, power loss, etc.
Press the [CANCEL] button to stop the alarm. The order of turning off is:
Alarm > Motion > Video Loss
Press [ENTER] to save the changes and to exit the menu.
Press [REC] after selecting “Record enable”, The red indicator at the recorder front panel
lights up and the recording starts.
