Page | 42
© Sansui UK 2012 WLD+201 IB Ver 1.0 Rev 0.0
16.
Troubleshooting and error messages
The WLD+201 is equipped with state-of-the-art technology and is safe to operate. Nevertheless, problems or malfunctions
may occur. Before contacting Sansui customer support, refer to the following for possible solutions.
PROBLEM
POSSIBLE SOLUTION
No power when switched on
-
Mains socket not switched on or faulty
-
Plug not fully inserted into wall socket
-
Internal mains fuse has blown inside the unit,
this will need to be replaced by a qualified service
technician
-
Power cord has become damaged, this should be
replaced immediately by a qualified technician
No sound
-
Power not turned on
-
Volume setting low
-
Loudspeaker cables not connected
-
No input audio equipment is connected or is faulty
-
Correct audio input source not selected on front panel
No sound in one channel
-
Audio source input cables connected incorrectly or
damaged
-
Audio input source faulty
Loudspeaker cables connected incorrectly or
damaged
-
Loudspeakers are faulty
Loud buzz or hum
-
Audio input cables damaged or not correctly
connected
-
Turntable earth lead incorrectly fitted
-
Turntable head shell incorrectly fitted.
-
CD player sited too close to TV
Weak bass, diffused stereo image
-
Speaker connections out of phase check + and – terminals
are connected to corresponding terminals on both
amplifier and loudspeakers
Distorted sound
-
Frayed wires may be touching on speaker terminals
causing distortion
-
Bass and treble controls may be too high for
loudspeaker specification.
-
Volume control may be set too high
Audio input source switches not
working
-
Internal fault would need servicing by a qualified service
technician.
Remote control not working
-
Check if the batteries have been inserted correctly.
-
If batteries are empty, replace them with new ones.
-
Point the remote control at the remote sensor and press to
operate.
-
Remove any objects found between the remote control
and the remote sensor.
-
Make sure the distance between the remote control and
the device does not exceed 8 m
Interference during reception
-
The reception frequency has not been set properly.
-
The antenna has not been positioned properly.
-
Start a station search.
