Sans Digital TOWERRAID TR8U, Руководство пользователя

Страница: 6 / 30

3 MODE SETTING
3.1 INTRODUCTION
The SANS DIGITAL TR8U-B/TR8U storage appliance is an easy-to-use storage that provides variety of modes;
you can simplely set up the mode by hardware DIP switch on the back panel. The mode shows as seen below.
3.2 DISK DRIVE MODE
Please read the notics carefully before you change disk drive mode. The following notices are intended to remind
you to operate the product correctly. Please read and ensure that you understand them before you proceed to
change disk drive mode.
•
Data will be lost, when the mode change.
•
Turn off the power of storage device before change mode.
•
2TB capacity is the limitation for each disk volume.
Switch the DIP 2 ~ 6 to setup the disk drive mode on the back panel. Please refer to the diagrams.
•
Standard Drive Mode: It is a JBOD mode, where the unit will access each hard drive individually. The
number of Hard Drive avalible to computer equal to the number of hard drive you installed.
•
8 Hard Disk Drive Combine Drive Mode: It is a single Spanning mode, where the unit will combine all of
the hard drives installed and accesses it like one large hard drive. There is only one hard drive shows on the
computer.
•
4 Hard Disk Drive Combine Drive Mode: It is a two set of Spanning mode, where the unit will combine
four of the hard drives installed and access it like two large hard drive. There are only two hard drives shown
on the computer.
•
2 Hard Disk Drive Combine Drive Mode: It is a four set of Spanning mode, where the unit will combine
two of the hard drives installed and access it like four large hard drive. There are only four hard drives
shown on the computer.