23 / 32
9.
Added Function
9-1. Soft Start and Soft Stop Functions
If the rising time or falling time of the feeder should be adjusted, change the settings of the soft
start or soft stop.
To change the settings, set the relevant parameter accordingly.
Parameter No. 0C: Soft start = The time until the set output is achieved after the operation
starts
Parameter No. 0d
：
Soft stop = The time until the stop is made from the set output after the
stop conditions are met.
The set time is 0.2
－
9.9 sec. (The default value is 0.2 sec.)
9-2.
Overflow Sensor Timer Function
The timer of the overflow sensor [in2 Input] is set in the parameter setting as follows:
Parameter No. 0A: ON delay = The time until the operation starts after the continuous sensor
signal ON status at a stop
Parameter No. 0b: OFF delay = The time until the operation stops after the continuous sensor
signal OFF status in operation
9-3.
Operation Signal Delay Output Timer Function
The motion of the operation signal delay output OUT3 can be delayed from the timing of the
feeder output.
Parameter No. 0E: Start delay = The time until the OUT3 becomes ON and the feeder starts
outputting after the feeder output meets the operation
conditions
Parameter No. 0F: Stop delay = The time when OUT3 remains ON after the feeder stops
outputting
9-4.
Output Voltage Limit Setting
The maximum value (100%) of the output voltage can be changed.
The value can be set by the parameter No.00 within a range of 1
－
99% (Invalid: When set to --,
100%)
※
The setting change can be made in the
“
n
”
mode when the Controller is in the stop status.
(a)
When the Vol
▲
key is continually pressed
Any value larger than the set value cannot be set.
<Setting example>
When the setting is made to the parameter No.00=50, the maximum value is 50.0%.
(b)
When the feedback is in operation (Setting: 0u=1)
The output boost by the feedback control is limited to the set value.
< Setting example >
When the setting is made to the parameter No.00=50, the controllable range by the
feedback control is 0
－
50.0%.
