Delet
e the measur
ed values
• To clear the memory of the relevant user memory,
you must first select a user memory.
• Start the retrieval of the average measured values.
A
flashes on the display and the average value of
all saved measured values in this user memory is
displayed.
• Press and hold the memory button
M
and the
START/STOP
button for 5 seconds, depend-
ing on the user memory you are in.
All values of the current user memory
are deleted and the device switches
off.
8. Error messages/troubleshooting
In the event of errors, the error message _ appears on
the display.
Error messages may appear if
• the systolic or diastolic pressure could not be meas-
ured (
or
appears on the display)
• the systolic or diastolic pressure was outside the meas-
urement range (“
Hi
” or “
Lo
” appears on the display)
• the cuff is fastened too tightly or too loosely
(
or
appears on the display)
• the blood pressure is higher than 300 mmHg for more
than 1.5 seconds (
appears on the display)
• pumping up takes longer than 180 seconds (
appears on the display)
• there is a system or unit error (
,
,
or
appears on the display)
• the batteries are almost empty
.
In such cases, repeat the measurement. Ensure that you
do not move or speak during the measurement. If neces-
sary, reinsert or replace the batteries.
Technical alarm – description
Should the recorded blood pressure (systolic or diastolic)
lie outside the limits specified in the section “Technical
specifications”, the technical alarm will appear on the
display indicating either “
” or “
Lo
”. In such cases, you
should seek medical assistance and check the accuracy
of your procedure.
The limit values for the technical alarm are factory set
and cannot be adjusted or deactivated. These alarm limit
values are accorded second priority under the standard
IEC 60601-1-8.
The technical alarm is a non-locking alarm and must not
be reset. The signal shown on the display will disappear
automatically after about 8 seconds.
30
Содержание SBC 15
