Sanitas SBC 15, Инструкция по эксплуатации

Страница: 24 / 80

4. Preparing for the measurement
Inserting the batteries
• Remove the battery compartment lid on the left side of
the device.
• Insert two 1.5 V micro (alkaline type LR03) batteries.
• Make sure that the batteries are inserted the correct
way round in accordance with the markings. Do not
use rechargeable batteries.
• Carefully close the battery compartment lid again.
If the battery replacement symbol
is displayed,
you can no longer perform any measurements and must
replace all batteries.
Battery disposal
• The empty, completely flat batteries must be disposed
of through specially designated collection boxes, recy-
cling points or electronics retailers. You are legally
required to dispose of the batteries.
• The codes below are printed on batteries
containing harmful substances:
Pb = Battery contains lead,
Cd = Batter contains cadmium,
Hg = Battery contains mercury.
Setting the hour format, date and time
It is essential that you set the date and time. Otherwise,
you will not be able to save your measured values cor-
rectly with a date and time and access them again later.
There are two different ways to access the menu
from which you can adjust the settings:
• Before initial use and after each time you replace the
battery:
When inserting the batteries into the device you will be
taken to the relevant menu automatically.
• If the batteries have already been inserted:
With the device switched off press and hold the
START/STOP
button for approx. 5 seconds.
In this menu you can adjust the following settings in suc-
cession:
Hour format
➔
Date
➔
Time
24