SaniServ 707, Руководство по эксплуатации

Страница: 9 / 24

DISASSEMBLY and CLEANING
Disassembly and Cleaning Procedure
1. Fill the machine with cold water and set each control
switch (Fig. 6) to the “CLEANOUT” position. DO NOT
use hot water which could damage the machine. Let the
machine agitate 1 to 2 minutes, then drain the water by
pulling downward on the spigot handle (Fig. 7). Repeat
the above procedure as necessary to make certain all
product is removed from the machine. After the machine
is empty, set the control switch to the
“OFF” position.
2. Prepare a suitable detergent and water solution at a
temperature of approximately 125 ° F. (52 ° C.) to 130 ° F.
(55
°
C.). For best cleaning results select a concentrated
anti
-
bacterial dishwashing detergent containing
biodegradable anionic and nonionic surfactants. Avoid
detergents containing phosphates. DO NOT use an
abrasive detergent on any part of the dispenser.
DO NOT USE HOT WATER.
DOING SO MAY DAMAGE THE MACHINE.
3. Make certain that the machine is “OFF”. Fill the mix
pan with the cleaning solution. Clean the mix pan
thoroughly with a brush as the solution drains into the
freezing cylinder(s). Clean the mix inlet tube(s) and the
restrictor tube holes with the brush provided.
4. Set the control switch (Fig. 6) to the “CLEANOUT”
position and agitate for approximately 1 to 2 minutes and
then drain the water by pulling down on the spigot handle
(Fig. 7). After the unit is empty, set each control switch to
the
“OFF” position.
DO NOT USE ANY TOOLS OR SHARP OBJECTS TO
REMOVE ANY O
-
RINGS FROM THIS MACHINE.
SHARP OBJECTS WILL DAMAGE THE O
-
RINGS.
5. Remove the front plate by turning the black plastic
knobs in a counterclockwise direction (Fig. 8).
Disassemble the front plate in the following manner:
a. Remove the faspin and spigot handle.
b. Remove the front plate o
-
ring.
c. With the spigot handle removed, push the spigot
plunger out the top of the front plate and remove all
lubricant from the spigot plunger.
d. Remove the o
-
rings from the spigot plunger by
grasping the part with one hand and with a dry
cloth in the other hand, squeeze the o
-
ring upward.
When a loop is formed, grasp the o
-
ring with the
other hand and roll it out of its groove and off the
spigot plunger (Fig. 9).
Fig. 7
Dispensing Product
Spigot Plunger
Faspin
Spigot
Handle
Front Plate
Front Plate O
-
ring
DO NOT LUBRICATE
Spigot Plunger
O
-
rings
Front Plate
Knobs
Fig. 6
Control Switch
Fig. 8
Front Plate Assembly
Fig. 9
O
-
Ring Removal
PAGE 4
AUTO
CLEANOUT
O
F
F
O
F
F
CAUTION
CAUTION