SaniServ 707, Руководство по эксплуатации

Страница: 14 / 24

2. Lubricate and assemble the front plate assembly in
the following manner:
a. Install the two o
-
rings on the spigot plunger by
rolling them onto the plunger. Seat the o
-
rings in
the grooves. Be certain that they are not twisted.
Smooth the lubricant into the grooves and over
the sides of the plunger assembly (Fig. 22).
b. Slide the lubricated spigot plunger into the front
plate (Fig. 23) making certain that the spigot handle
slot is aligned to the front.
C.
Insert the spigot handle and secure with the faspin.
d. Install the front plate o
-
ring.
DO NOT LUBRICATE THE FRONT PLATE O
-
RING
PAGE 9
Fig. 21
Dasher with Blade (Front View)
ASSEMBLY and LUBRICATION
Approximately 1/8 inch
Exposed
Fig. 22
Spigot Plunger Lubrication
Lubricate Shaded Area
e. Secure the front plate assembly with the two
plastic knobs. Simultaneously, turn the knobs in a
clockwise direction. Tighten the knobs evenly.
DO NOT tighten one knob all the way down and
then the other. Doing so may result in front plate
breakage. Only moderate force is required.
DO NOT over tighten. Close the spigot plunger.
3. Install the drip tray and drip tray insert (Fig. 24).
4. Proceed to the “Sanitizing” section of this manual.
Drip Tray Support
Remains Attached
To Machine Front
Drip Tray
Fig. 24
Drip Tray
Assembly
Drip Tray Insert
Spigot Plunger
Faspin
Spigot
Handle
Front Plate
Front Plate O
-
ring
DO NOT LUBRICATE
Spigot Plunger
O
-
rings
Front Plate
Knobs
Fig. 23
Front Plate Assembly