Saniflo SANIFOS 110 P, Руководство по эксплуатации и установке

Страница: 20 / 36

18
5.1 Installing the pumping station, floor-standing
• The characteristics shown on the rating plate have been compared with those on the order and installation (supply
voltage, frequency).
• The installation room must be protected against frost.
• The installation room is adequately lit.
• The work has been prepared in accordance with the dimensions shown in the example installation and standard EN
12056-4.
• The plant room where the SANIFOS
®
will be installed must be large enough to allow a 600 mm clearance around
and above the device to facilitate maintenance.
• Stop valves (provided with certain devices) must be fitted on the effluent inlets as well as on the discharge line, as close
as possible to the pumping station.
• The discharge line must be designed to prevent any back-flow of sewage.
By fitting a non-return loop, located above the back-flow level, back-flow is avoided.
Please note:
Unless otherwise specified locally, the back-flow level is the level of the highway (roads, pavement, etc.).
Extend this line after the non-return loop through a larger diameter pipe.
• Provide a sump to drain the room.
• The installation of an auxiliary pump for possible drainage of the plant room (for floods) is recommended.
• The pumping station must be ventilated above the roof.
• The pumped fluid is appropriate and authorised by this documentation (
➜
section 3.5, page 12).
• In case of discharge of greasy effluents, the use of a degrease tap is essential.
Wastewater other than those mentioned above, for example, of artisanal or industrial origin, must not be discharged
into the pipes without prior treatment.
5.2 Installing the pumping station, underground
Before burying the pumping station, a soil analysis must be carried out. This analysis must comply with DTU 64-1 and
the Order of 6 May 1996.
SANIFOS
®
610 installation
SANIFOS
®
280 installation
with extension