Sangoma T3 Mux M13, Руководство пользователя

Страница: 30 / 30

30
Section 4 : Maintenance
4.1 Firmware Upgrade
To upgrade T3Mux firmware, you need T3MuxUp.exe program and the firmware .eld file ready on
a MS Windows host computer (we use the term “host” to refer to the MS Windows computer and “target” to
refer to the T3Mux equipment).
The T3MuxUp.exe program can be downloaded from:
ftp://ftp.sangoma.com/T3Mux/T3MuxUp.exe
Before proceeding firmware upgrade, please make sure the host and target are connected through the serial
cable. Serial cable is the only way to upgrade firmware. Telnet communication is not able to complete this job.
If this is your first time connecting the target using serial port, please follow the steps in section 2.3.2 for
instructions on establishing Serial connection with T3Mux. Once you are connected to the target T3Mux
equipment using serial port, and you are ready for firmware upgrade.
To start updating firmware, you need to reset or reboot your T3Mux. When your T3Mux is boot up,
the lights of the ports will flash about 10 seconds, run this program when the lights are flashing.
You also could start Windows program first and reboot T3Mux within 60 seconds. They would
establish communication and start updating firmware automatically.
To run T3MuxUp.exe, open a command line window (click Start->Run and type cmd then click Enter). Go to
the firmware file’s folder (ie. $ cd C:\Program Files\T3Mux). In the command line, type:
$ T3MuxUp.exe –i com1 T3Mux-1.7.1.eld
In the above command, “com1” is the serial port the Windows computer is actually using. “T3Mux-1.7.1.eld” is
the firmware file name that you want to upgrade with. Click Enter to run the program and reboot T3Mux
equipment, the upgrade will begin. When it’s finished, the upgrade program will tell it’s succeeded or failed.
The upgrade may take about 4~5 minutes to complete.