KSwitch D4 MM Managed Ethernet Switch - Preliminary User Guide, Rev. 0.9
// 31
5.3.
Wall Mounting
To mount on a flat surface or wall use the Wall Mount Kit containing two wall mount plates and four screws, see
Table 2: List of Accessories.
The number of wall mount plates required to mount the switch and the position of the wall mount plates on the rear
side of the switch, depends on the switch’s port variant
Figure 14: Wall Mount Plate
1
2 screws hole to mount on the
switch
2
Grove to mount with screw on a wall or
flat surface
Table 6: Wall Mount Plates for the Switch Port Variants
8/10/12/14-port
18-port
28-port
The distance from the wall mount plate’s mounting holes to the top of the wall mount plate
is 27 mm.
To install the wall mount plate supplied in the Wall Mount Kits, perform the following:
1.
Make sure the mounting surface is clean and smooth and meets the thickness requirement of the screw.
2.
Aline the wall mount plate to the correct threaded holes (top and bottom) of the rear side of the switch.
Mount on a wall or flat surface using the specified number of wall mount plates and screws
to ensure the switch is secured properly.
3.
Fasten the wall mount plates to the switch (top and bottom) using the screws (length 5 mm & size M3) provided.
4.
Mount the switch to a wall or flat smooth surface by inserting screws into each wall mount plate’s grove and
fastening firmly.
27 mm
27 mm
1
2
