COMe-mEL10 - User Guide Rev. 1.1
// 44
5/
COMe Interface Connector
The COMe interface connector (X1A) mounted on the bottom side of the module contains 220-pins with two rows
where row A contains pins A1 to A110 and row B contains pins B1 to B110.
Figure 10: COMe Interface Connector
1
COMe interface connector (X1A)
2
X1A, Pin A1
3
X1A, Pin B1
5.1.
Connecting COMe Interface Connector to Carrier Board
The COMe interface connector (X1A), is inserted into the corresponding connector on the carrier board and secured
using the mounting points and standoffs. The height of the standoffs (either 5 mm or 8 mm) depends on the height of
the carrier board’s connector.
The module is powered on by connecting to the carrier board using the interface connector.
Before connecting the module’s interface connector to the carrier board’s corresponding
connector, ensure that the carrier board is switch off and disconnected from the main power
supply. Failure to disconnect the main power supply could result in personal injury and
damage to the module and/or carrier board.
Observe that only trained personnel aware of the associated dangers connect the module,
within an access controlled ESD-safe workplace.
To protect external power lines of peripheral devices, make sure that: the wires have the
right diameter to withstand the maximum available current. The enclosure of the peripheral
device fulfills the fire-protection requirements of IEC/EN 62368.
2
3
1