COMe-mEL10 - User Guide Rev. 1.1
// 68
Sub-screen
Next Level Sub-screens / Description
SIO
Configuration>
(continued)
Active Serial
port>
(continued)
Possible: Use
Automatic
Settings>
Allows the user to change the device’s resource
settings. New settings are reflected on the setup
page after system restart.
[Use Automatic Settings,
IO=3F8h; IRQ=4, DMA;
IO=3F8h; IRQ=3,4,5,7,9,10,11,12; DMA;
IO=2F8h; IRQ=3,4,5,7,9,10,11,12; DMA;
IO=3E8h, DMA; IRQ=3,4,5,7,9,10,11,12; DMA;
IO=2E8h; IRQ=3,4,5,7,9,10,11,12; DMA]
Warning! Disabling SIO logical devices may have unwanted side effects. Proceed with caution!
Active Parallel
Port>
Use this Device>
Enable or disable use of this logical device
[Enabled, Disabled]
Logical Device
Settings Current>
Read only field
IO=378h; IRQ=5;
Possible: Use
Automatic
Settings:>
Allows the user to change the device’s resource
settings. New settings are reflected on the setup
page after system restart.
[Use Automatic Settings,
IO=378h; IRQ=5,
IO=378h; IRQ=5,6,7,9,10,11,12
IO=2F8h; IRQ=5,6,7,9,10,11,12,
IO=3E8h, DMA; IRQ=5,6, 7,9,10,11,12
IO=2E8h; IRQ=5,6,7,9,10,11,12]
Mode>
[STD Printer Mode, SPP Mode, EPP-1.9 and SPP
mode, EPP-1.7 and SPP mode, ECP Mode, ECP and
EPP 1.9 Mode, ECP and EPP 1.7 mode]
Warning! Disabling SIO logical devices may have unwanted side effects. Proceed with caution!
Warning! Changes made during setup session will be shown after you restart
Sub-screen
Next Level Sub-screens / Description
PCI Sub System
Settings>
PCI Settings Common for all Devices:
BME DMA
Mitigation>
Re-enable Bus Master Attribution disabled during PCI enumeration for
PCI Bridge after SMM locked.
[Enabled, Disabled]
Change settings of the following PCI devices:
Warnings: Changing the PCI device settings may have unwanted side effects.
System may hang! Proceed with caution.
Sub-screen
Next Level Sub-screens / Description
USB
Configuration>
Read only field
USB module version Controller and devices
Legacy Support>
Auto: disable legacy if no USB devices are connected
Disable: keeps USB devices available only for EFI applications
[Enabled, Disabled, Auto]
XHCI Hand-off>
This is a work around for OSs without XHCI hand-off support. The XHCI
ownership change should be claimed by XHCI driver
[Enabled, Disabled]
USB Mass Storage
Driver Support>
[Enabled, Disabled]