KBox B-201-CFL - User Guide, Rev 1.3
// 29
To open the chassis, perform the following:
1.
Close all applications. Shut down the product properly and disconnect the power cable from the power
source. Disconnect all peripherals.
2.
Place the KBox B-201-CFL on a flat, clean and ESD-safe surface.
3.
Remove the two top cover screws on the rear panel (Figure 10) and retain the screws to secure the top
cover later.
Figure 10: Top Cover Fastening Screws
4.
Lift the top cover a few centimeters at the rear of the chassis and then pull the top cover gently away from
the front panel to release the top cover from the holding brackets (Figure 11) on the front panel.
Figure 11: Holding Brackets
5.
Lift the top cover vertically away from the chassis to avoid damaging the internal fan assembly. Do not side
the top cover off the chassis.
Do not slide the top cover off the chassis!
Avoid contact and possible damage between the top cover and the internal fan assembly by
moving the top cover, when released from the holding brackets, vertically upwards.
To close the chassis, perform the following:
1.
Place the KBox B-201-CFL on a flat, clean and ESD-safe surface.
2.
Hold the top cover a few centimeters above the main chassis almost in the correct position.
Do not slide the top cover on to the chassis!
Avoid contact and possible damage between the top cover and the internal fan assembly by
moving the top cover vertically downwards.
3.
Tilt the front of the top cover downwards towards the front panel and carefully push the top cover onto the
holding brackets (Figure 11) on the front panel, until the top cover is in-line with the front panel.
4.
Move the opposite side down onto the rear panel and secure with the two screws retained in Opening the
Chassis, step 3.
Top cover screws
Holding brackets
