10
1. On the first installation the freesat installation screen will
be displayed.
The signal check bar shows the strength and quality of the freesat
signal received from your satellite dish. If the signal strength or
quality is below 50%, you should check the satellite dish connection
at the back of the unit (switch the unit off and reconnect the cable if
necessary). If you are having trouble with the satellite dish, consult
your dealer or installer.
When the signal strength and signal quality are 50% or more,
continue tuning the unit. Press the
OK button to continue.
Step 1 of 6
Step 2 of 6
Step 3 of 6
Step 4 of 6
Step 5 of 6
OK
Continue
Step 6 of 6
First Time Installation
INFORMATION
i
Network ID
Your receiver has found the Network ID and Transport ID
Press OK to Continue
Transport ID
Lock Indicator
003b
090b
OK
Step 1 of 6
Step 2 of 6
Step 3 of 6
Step 4 of 6
Step 5 of 6
OK
Continue
Step 6 of 6
First Time Installation
INFORMATION
i
Postcode
Enter your postcode using the number buttons
Please note that the space is automatically entered in the postcode
Press OK and then select your screen type using the right arrow
TV Screen Size
C M 7 7 7 A T
Widescreen (16:9)
Step 1 of 6
Step 2 of 6
Step 3 of 6
Step 4 of 6
Step 5 of 6
OK
Continue
WARNING
!
Make sure that your receiver has been connected correctly
before continuing the installation
If signal strength is less than 50%
please check the dish alignment and connections
Signal Strength
100%
50%
25%
75%
Step 6 of 6
First Time Installation
First Time Installation
2. The receiver will automatically search for the Network ID and Transport
ID, this may take a few seconds. Once these have been found, the ID
boxes will be populated. Once the boxes have been populated, press the
OK button to proceed.
3. Enter your postcode by using the
number buttons on the remote
control. You do not need to enter a space. Once you have entered your
postcode, press the
OK button to continue next step.
Press the
buttons to select the screen format of your TV (16:9
Widescreen or the squarer 4:3 Traditional). Press the
OK button to
display next step.
Enter your postcode using the 0-9 buttons on the remote control. Press each number
repeatedly to produce the relevant letter (printed above each button), or number, in the
same way as ‘texting’ with a mobile phone. For example, for an ‘S’, press the 7 button four
times. Press the button to move to the next space. If you make a mistake, the button
deletes the last character entered.
If the signal strength is too low for reliable reception the scan will not proceed.
You can only use the unit after the first time installation has successfully completed.
The Network ID refers to freesat reception. It is not an indicator of internet connectivity!
SHDFSAT12_IB_V2.indd 10
13/06/2013 12:19
