ENGLISH
11
NT_51897201_RHE-AN_130516.docx
Z
Z
Handling
3.3
The units are delivered screwed to pallets.
The RHE dual flow air handling units can be handled by a pallet transporter, a forklift, or a crane. The
handling machines will be adapted to the load and the lifting conditions. In all cases, the lifting will be done
at the device’s base. The centre of gravity is located at the centre of the unit.
The device must be carefully manipulated only in the horizontal position. Ø 50 mm. holes are provided for
in the frame to allow passing a pipe to hook the slings. To avoid deteriorating the unit’s envelope, long
length slings and lifting beam spacers must be used.
In case a forklift / pallet transporter is used, the forks should be long enough to avoid pushing in the lower
panel. Position the forks low enough so as to not damage the doors. Lift gently.
Placement and anchoring
3.4
Placement
The RHE dual flow air handling units must be laid on a smooth horizontal surface capable of withstanding
the load. The RHE HD / VD Integral units are designed for an installation inside the premises. Only the OI
versions delivered with a roof can be used outdoors. In all cases, provide for ducts, connection
accessories, heater antifreeze protection and antivibration equipment. In heavy snowfall zones, an
additional protection must be provided for.
It is important to provide for enough space (Z minimum) to allow opening the doors, commissioning and
maintenance (filters, fans, heat exchanger). Do not position the unit against a wall to avoid the
transmission of structurally borne noise.
Type
Z
(mm)
RHE 1300
1450
RHE 1900
1500
RHE 2500
1800
RHE 3500
2100
Lifting with forklift
Spacer
Lifting with crane
