Instructions for the installer, maintenance
technician and final user
Page 45 of 54
© SandenVendo Europe SpA
5.5.4 Yearly Cleaning
In addition to the daily, weekly and monthly cleaning operations:
» If necessary recharge the refrigerant system gas.
» Check the integrity of the vending machine and the compliance with the standards of the
relative systems by qualified personnel.
5.6 Assembly / Disassembly for Maintenance
Attention!
All the operations indicated in the following paragraphs (5.6.1, 5.6.2, etc.) must be carried out
by qualified personnel.
Attention!
Contact technical assistance to request further support for any difficult operations.
5.6.1 LED Replacing
To replace the LED tubes, proceed as follows:
» Open the vending machine door;
» Turn off the vending machine from the main switch;
» Disconnect the wiring of the LED tubes on the inner part of the door around the delivery
area;
» Through the hole on the inner part of the door: replace the desired LED tubes;
» Connect the new LED tube..
Once the replacement operations have been completed, proceed as follows:
» Turn on the vending machine from the main switch.
» Close the door.
NOTE: with the door open, the LEDs turn off automatically.
5.6.2 Door Gasket Replacement
» Open the vending machine door;
» Turn off the vending machine from the main switch;
» Open the upper internal door and / or remove the lower internal door;
» Pull the damaged gasket firmly until it is removed from the seat in the
side profiles;
» Insert the new gasket in the seat on the door profiles;
» Fit the gasket well even in the corners, where it will be more difficult.
The gasket is fixed interlocking in the profiles on the door.
