Instructions for the installer, maintenance
technician and final user
Page 19 of 54
© SandenVendo Europe SpA
3.2 Unpacking
Upon receipt of the vending machine check that has not been damaged during transport or
that the packaging has not been tampered.
The packaging must be intact, ie:
It must not present dents, signs of shocks, deformations or breakages of the container;
It must not have wet areas or signs that could suggest that the casing has been exposed
to rain, frost or heat;
It must not show signs of tampering.
If damaged on receipt, any nature, immediately make a claim to the carrier and notify
either the importer or the dealer.
The packaging materials must be carefully removed in order to not damage the
distributor, inspect the inside and outside of the container to check for any damage.
Remove the transparent protective film, the four corners and the bag from the vending
machine;
After removing the external packaging, take the key located in the coin return
compartment;
Open the door, paying attention to the snap movement of the handle;
Remove the packaging components or equipment supplied which could prevent the
correct operation of the vending machine;
Remove the wooden bases and install the feet as indicated in paragraph 3.2.1
The packaging materials must be disposed of respecting the environment..
SandenVendo declines all responsibility for damage caused by failure to observe the
precautions listed in this section.
