Instructions for programming
BB01 Board functions
23
© SandenVendo
5.5.10 C12 Accepted banknotes in low change condition
(only MDB from Software version BBM 2.23)
This parameter is used for determining the acceptance of up to 8 bills (depending on the
bill validator program) when the changer is in low change condition.
Bill 1 is assumed to be the smallest in value, 8 the highest bill
Each bill has a binary value as
In C12
bill 1
= 1
bill 2
= 2
bill 3
= 4
bill 4
= 8
bill 5 = 16
bill 6 = 32
bill 7 = 64
bill 8 = 128
EXAMPLE
: If you want to accept bills 1 + 2 you must add the correspondent values:
C12 = 1 + 2 =
3
5.6 Money counter routine (if available)
If the correct password is entered and if the ENTER button is activated at the "
MONEY
"
prompt the VMC will enter the money counter routine. Upon entry into this routine the
display will show a "
G bo
" / "
-XXXX
" / "
XXXX-
" message where "
XXXX
" characters are the
total money on the cashbox. Using up button you see the other money counter submenu:
"
G BO
" / "
-XXXX
" / "
XXXX-
" money on cashbox
"
G TUB
" / "
-XXXX
" / "
XXXX-
" money on the coinage tube
"
G RET
" / "
-XXXX
" / "
XXXX-
" money gave from the coinage as change.
"
G NAN
" / "
-XXXX
" / "
XXXX-
" money gave from the coinage using manual payout submenu.
"
G CAR
" / "
-XXXX
" / "
XXXX-
" money paid using a card.
"
G BIL
" / "
-XXXX
" / "
XXXX-
" money on bill stacker
"
-XXXX
" is the highest digit and "
XXXX-
" is the lowest.
5.7 Set configuration
If the correct password is entered and if the ENTER button is activated at the "
SET
"
prompt the VMC will enter the machine configuration setting routine. The display will show
a "
ST
" message where the "
1
" indicates configuration setting number 1. Using UP and
DOWN button will cycle through the available configuration setting numbers. Activation of
the ENTER button while a configuration setting number is displayed will allow access to
the current setting number of the displayed configuration setting.
Activation of the ENTER button will save the displayed configuration. Activation of the
HOME button while configuration is displayed, without doing an ENTER before, will return
the VMC to the "
SET
" display without saving the displayed configuration. Activation of the
HOME button returns the VMC to the normal door open state.
Содержание Vendo BB01
Страница 13: ...Instructions for programming BB01 Board functions 11 SandenVendo...
Страница 14: ...Instructions for programming BB01 Board functions 12 SandenVendo...
Страница 33: ...31 SandenVendo...
Страница 34: ...32 SandenVendo 6 28 10 2014 Update Address page Update CONF C11 C12 22 23 Update Annexe Software BB01 30...
