Sanden Vendo BB01, Руководство по программированию

Страница: 16 / 34

Instructions for programming
BB01 Board functions
14
© SandenVendo
4 SERVICE ROUTINE
In the service mode, information such as sales by selection, total sales, total cash flow
through the machine, and diagnostic error codes can be accessed by using the selection
buttons and the electronic display. In addition, storage column assignments and vend
pricing can be set in this mode using the same techniques. The service mode can only be
entered when the vender door is open and when the service mode switch is activated.
The selection switches are used to step through the various programming function as
described in the previous page.
After entry into the service mode the operator can select one of several routines to read
data registers or to program machine configuration information. This level is called the
code level. Each of these paths is identified by a service code. The code for the various
paths are as follows.
EROR Error routine
CPO Coin Payout Routine
TUFL Tube Fill Routine
TEST Test Vend Routine
CASH Cash Counter Routine (Pass)
SALE Sales Counter Routine (Pass)
PRIC Prices Setting Routine (Pass)
STOS Spaces to sales Setting Routine (Pass)
CONF Machine Configuration Setting Routine (Pass)
SET Audit Setting and Message Setting (Pass)
ACCP Coin rejector parameter setting (Pass) (only for executive eprom)
RTN Return to normal mode door open state
Codes followed by a (Pass) indicate that they are password protected features and cannot
be accessed from the selection panel until the correct password has been entered while
the display reads
"PASS" .
Pass code is
4-2-3-1 .
The purpose of this password is to prevent accidental reprogramming by the operator.
P
ro
te
c
te
d
m
e
n
u