S&C IntelliCap, Руководство по установке, Страница: 6 / 24

6
S&C Instruction Sheet 1022-510
Applicable Software
This instruction sheet was prepared for use with IntelliCap
software:
ICAP109S and IVAR109S .
Software identification is shown on the IntelliLink ® Setup
Software Troubleshooting>Control & Switch Information
screen. For questions regarding the applicability of informa-
tion in this instruction sheet to future product releases, please
contact S&C Electric Company.
Pre-Installation Checklist
Before installing the IntelliCap control, carry out the following
steps in the shop:
STEP 1. Inspect the control for visible damage.
Make sure there is no obvious damage to the
control enclosure or any internal components.
STEP 2. Check whether a sensor cable may be needed.
With var sensing, the control may require a
connection cable for the sensors.
STEP 3. Use the required setup software and equipment.
It is possible to use the faceplate switches
and LCD screen for initial setup of an IntelliCap
control, but using IntelliLink software is easier
and faster. The faceplate switches can be used for
later adjustments in the field. Equipment needed
includes:
• A personal computer The computer should
have a Microsoft Windows ® 7 or 10 operating
system, Internet Explorer 5.0 or higher, 32 MB of
RAM, a USB or serial port, and Internet access to
the S&C Automation Customer Support Portal.
• A serial communication cable This cable
connects the computer to the LOCAL COMM
PORT on the control. Use a straight-through
cable, not a null-modem cable. The cable must
be long enough to connect to an installed
IntelliCap control.
The serial connection is RS232 with a
DB9-pin connector.
If the computer only has USB ports, use a
serial-to-USB cable adapter.
STEP 4.
Do one of the following:
• Go to the installation site and install the
IntelliCap control. Then configure the control
as described in Instruction Sheet 1022-530, ”S&C
IntelliCap
® Automatic Capacitor Control: Setup .”
• Complete the configuration steps summarized
in the “Optional In-Shop Setup” section while
you are in the shop. Then install the control at
the site.
Optional In-Shop Setup
The following steps can be completed while you are still in
the shop or later at the installation site:
STEP 1.
Install the IntelliLink software on your computer.
For details, see the “Install the IntelliLink
Software” section in Instruction Sheet 1022-530,
“S&C IntelliCap
® Automatic Capacitor Control:
Setup .”
STEP 2.
Configure the control software.
Most of the software setup can be done in the
shop. For an explanation of how to configure
the software, see the “Setting Up the Capacitor
Control”
section in Instruction Sheet 1022-530, S&C
IntelliCap ® Automatic Capacitor Control: Setup .”
Installation