S&C IntelliCap, Руководство по установке, Страница: 15 / 24

S&C Instruction Sheet 1022-510
15
For a Metal or Concrete Pole
Follow these steps to attach the enclosure to a metal or
concrete pole:
WARNING
The control must be set to Manual mode to avoid
unexpected operation of the capacitor bank during
installation or setup operations .
STEP 1.
Pass a stainless steel strap or clamp through the
two upper mounting slots in the bracket. Pass a
second strap through the two lower mounting slots.
STEP 2.
Lift the control into position on the pole. Then
support the control while tightening the upper and
lower straps around the pole.
STEP 3.
Confirm that the cable from the switch and power
source is wired correctly for the connector on this
control. See Figure 11 on page 16.
A br a cke t - mou nt e d c o nt r ol m ay h a ve
a d d i t i o n a l s e n s o r - c a b l e c o n n e c t o r s
installed on the bottom of the enclosure. The con-
nector configuration is shown on a label inside the
enclosure door.
STEP 4. Connect the ground lug.
Use the ground lug on the bottom of the enclo-
sure to ground the control. See Figure 10 on page
13. The ground lug accommodates up to #2 copper
or aluminum, solid or stranded wire.
WARNING
The control must be properly grounded . You must read
and understand all applicable grounding codes and
requirements for your service area before installing this
control .
STEP 5.
Connect the cable from the junction box to the
connector on the bottom of the control.
When an energized cable is connected to the
control, after a few seconds the LCD screen will
start to scroll.
Installation