5
INSTALLATION STEPS:
Determine where you want to mount the Helmet Particle Separator. The intake
can face forwards or backwards, but it needs to be mounted horizontally,
with the Exhaust Fan pointing straight down. It is recommended to mount
the Helmet PS in an orientation where there is less dust entering the vortex
separators. Also note the Fan Speed Knob is between the Helmet Ports.
1
Install the L Brackets (
E
) onto the Adapters with the Screws (
G
), Washers (
F
),
and Thread Locker (
O
), selecting the proper angle and orientation based on
the desired location for the Particle Separator, then tighten. Tool Needed: 5mm
Hex Key
3
Install the Pivot Bodies (
H
) with the Screws (
I
), Washers (
F
), and Locknuts (
J
).
Snug the straps up, but do not fully tighten, leave the straps loose enough so
they can be slid side to side and rotated. Tools Needed: 13mm Wrench, 5mm
Hex Key
5
Install the Adapters (
B
) onto the Helmet Particle Separator Assembly (
A
) with
the Screws (
D
), Washers (
C
), and Thread Locker (
O
), then tighten. Tool Needed:
4mm Hex Key
2
Slide the Straps (sold separately) over roll cage. Wrapping a small parts bag
around the roll cage will make sliding the strap over the roll cage easier and
help protect the roll cage from scratches.
4
Install the L Brackets (
E
) onto the Pivot Bodies (
H
) using the Screws (
G
) and
Washers (
F
), and Thread Locker (
O
), then tighten. Tool Needed: 5mm Hex Key
6
Содержание 76-6000
Страница 4: ...EXPLODED VIEW 3...
