- 23 -
FP120D,FP145D
Die set are stored in the storage locker and installed in the master dies with a quick change tool one
set at a time.
Changing the die set 10 with the quick change tool is not recommendable. The die set may get broken
due to the tool rod’s diameter. The die set no 74 and larger die sets have not quick change possibility.
these dies are too thin for quick change tool holes.
(1) Before installing dies, make sure that master dies are clean.
(3) After that, start the motor and select manual mode.
(4) Set the swaging diameter dial to 0. 0.
(5) Open the master dies.
(6) Insert the pins of the tool into the die set in the locker, turn
the tool clockwise and pull the whole set out.
(7) Hold the handle of the quick change tool as shown in figure
1. and make sure your hand will not get between the dies.
(8) Turn down the centering lever behind the dies.
(9) Mount the die set between master dies so that the tool rod is fitted deep enough in the centering
hole and start closing the dies in manual mode.
Die can also be changed one by one with a change tool:
(1) Select MANUAL MODE
(2) Open the master dies and STOP THE MOTOR
CAUTION ! ALWAYS TURE OFF THE POWER PRIOR
TO INSTALLATION OR CHANGE OF DIES WITH THE
CHANGE TOOL.
(3) Prior to installing dies, clean the contact surfaces of both
the die and master dies properly to avoid damaging the
surfaces.
(4) Pull the pin in the master die with the tool delivered
together with the machine.
(2)
STOP THE MOTOR PRIOR TO CLEANING DIES.
CHANGE OF A SINGLE DIE
QUICK CHANGE
(Only provides to the FP145D USE)
CE Instruction Manual
www.samway.com
