Chapter 8. General Settings
69
Screen Scroll Step Size.
Defines the number of pixels the horizontal manual screen
scroll should move for each step.
Paged Scrolling.
When set to
Yes
scrolling vertically on pages that surpass the
screen size will page up/down instead of simply changing lines. This can be
useful on slow displays.
List Acceleration Start Delay.
This setting enables the acceleration of scroll speed
in lists when holding
Up
or
Down
. When set to
Off
the acceleration is
disabled. When any other value is set the acceleration will start to accelerate
after holding
Up
or
Down
for the chosen time (in seconds).
List Acceleration Speed.
This setting controls how fast the scroll speed acceler-
ates. The scroll speed will increase every N seconds. For example, selecting
Speed up every 3s
will increase the scroll speed every 3 seconds while
Up
or
Down
is held.
Peak Meter.
The peak meter can be configured with a number of parameters.
Peak Release.
This determines how fast the bar shrinks when the music becomes
softer. Lower values make the peak meter look smoother. Expressed in scale
units per 10 ms.
Peak Hold Time.
Specifies the time after which the peak indicator will reset. For
example, if you set this value to 5 s, the peak indicator displays the loudest
volume value that occurred within the last 5 seconds. Larger values are useful
if you want to find the peak level of a song, which might be of interest when
copying music from the player via the analogue output to some other recording
device.
Clip Hold Time.
The number of seconds that the clipping indicator will be visible
after clipping is detected.
Clip Counter.
Show the number of times the clip indicator went active during
recording in front of the peak meters.
Scale.
Select whether the peak meter displays linear or logarithmic values. The
human ear perceives loudness on a logarithmic scale. If the Scale setting is
set to
Logarithmic
(dB) scale, the volume values are scaled logarithmically.
The volume meters of digital audio devices usually are scaled this way. On
the other hand, if you are interested in the power level that is applied to
your headphones you should choose
Linear
display.
This setting cannot
be displayed in units like volts or watts because such units depend on your
headphones.
Minimum and maximum range.
These two options define the full value range
that the peak meter displays. Recommended values for the
Logarithmic
(dB) setting are -40 dB for minimum and 0 dB for maximum. Recommended
values for
Linear
display are 0 and 100%. Note that -40 dB is approxi-
mately 1% in linear value, but if you change the minimum setting in linear
The Rockbox manual
(version 3.14)
Samsung YH-920