6
CONNECTING THE DRAIN HOSE
After pressing the joint ring(a), insert the drain hose(b)
to drain direction.
(a)
(b)
•
When a proper amount (one time does) of fabric
softener is stored in the softener inlet,it is
automatically put in at the last rinsing cycle.
•
Do not use detergent, bleach or starch into
the Softener Inlet.
•
Using too much softener may produce
unsatisfactory results.
•
Do not open the lid during the Spin Dry cycle.
If added too early, its effectiveness will decrease.
•
Do not leave the softener
into the Softener
Dispenser for a long time.
Because softner
became stiff.
HOW TO ADD THE FABRIC SOFTENER
WATER SUPPLY CONNECTOR FILTER
1.Pull out the filter and wash well.
2. Pull in the filter and connect
the hose to the inlet water
valve tightly.
inlet water
valve
3. Check if there is a leakage.
Note to tighten up the
connector.
CLEANING THE FILTER NET
Clean the filter net often to keep the washer clean.
1. Push the upper part
of the filter and pull in.
2. Open the cover as
shown in the figure.
3. Clean the filter.
4. Close the cover and insert the
lower part of the filter in the
basket first and then push the
filter with "click" sound .
1
. Check the 4 Legs.(Front-right. Front-left. Rear-right. Rear-left)
2
. Lay down the Washing Machine to the front.
3
. Insert the hook of leg in to the square hole of base.
4
. Push the leg to the arrow direction to “Click”.
5
. Finaly fix the legs on the base with screw like a figure.
HOW TO ASSEMBLE THE LEGS
1
2
Base
Hole
Hook
Screw
HOW TO CLEAN THE FILTER
1
. Place a rag under the washer filter not to wet the floor.
2
. Rotate the filter counterclockwise
and pull out the filter.
3
. Remove dirts and rotate
the filter clockwise
until it locks in position.
(pump drained washer)
1.
Place a rag under washer filter not to wet the floor.
2.
Turn the filter-cap to the left.
3.
Take the filter out and
remove dirts.
4.
Reassemble in
reverse order.
WA80N-BP5-02197A-GB-0616ÃÑ.indd 7
WA80N-BP5-02197A-GB-0616ÃÑ.indd 7
2005-06-17 ¿ÀÈÄ 1:44:06
2005-06-17 ¿ÀÈÄ 1:44:06
