5
M a i n t e n a n c e
The Pre-Motor Filter protects the
motor from dirt particles.
It is located in the slide out tray
underneath the Dirt
Container. If the filter becomes dirty,
pull out the tray, lift
out the filter and clean.
The Post-Motor Filter assists in the
filtration process to return clean air to
the room. It is located behind the
door on the side of the cleaner. If the
filter becomes dirty, open the door,
remove the filter and clean.
Note: A white, pleated HEPA
Media Filter is offered as an
optional item. This filter is not
washable and must be replaced.
WARNING:
Do Not operate cleaner with damp or
wet filters or without all
filters in place.
The belt on your cleaner causes the
agitator to rotate and is important for
the effective operation of the
cleaner. The belt is located under
the bottom plate of the cleaner and
should be checked from time to time
to be sure it is in good condition.
Disconnect cleaner from
electrical outlet.
To check belt, remove bottom plate
as shown in “How to replace.”
Replace belt it is stretched, cut or
broken.
Remove agitator and used belt.
Discard used belt.
3-6
3-7
Insert agitator through belt and place
belt in belt guide (C) on agitator.
Should the agitator shield (D)
become dislodged while replacing
the belt or the agitator, reposition it
as shown, noting the placement of its
belt guide (D)
3-9
With lettering on outside of belt and
positioned as shown in box on (D),
slide new belt over motor pulley (B).
3-8
Disconnect cleaner from electrical
outlet.
Place handle in low position and turn
cleaner over so bottom side is up.
Remove the 4 screws as shown with
a screw driver.
3-5
Post-Motor
Filter
P r e - M o t o r
Filter
3-4
Note: For easier
access, the entire
Upper Tank may be
removed by turning the
knob on the back
of the cleaner to unlock
and pulling the entire
tank straight out.
Cleaning The Pre-Motor and
Post-Motor Filters
The belt
How to replace
When to replace
