2
A s s e m b l i n g Pa r t s
The assembled cleaner will look like the illustration to the left.
Hose Clip
Handle
Power Switch
Louvers
Upper Tank
Frame and
Filter(Inside
Louvers)
Upper Tank
Post-Motor Filter
Hepa Media Filter
(Optional Item)
Lock ’n Seal™
Lever
Handle
Release Pedal
Furniture Protection Guard
Powerfoot
Height
Adjustment
Knob
Pre-Motor Filter
Dirt Container
Power Cord
Stretch Hose
Quick Release
Cord Wrap
Carrying
Handle
Quick Reach
Handle
Hose Wand
Dusting Brush
Extension Wand
Upper Tank Knob
Crevice Tool
Hose
Wand Base
Locate the vacuum
Handle and remove the
screw packet taped to
the base of the Handle.
Stand the vacuum
upright and slide the
base of the handle firmly
into the grooves at the
top of the vacuum body.
Check to be sure the Handle
is fitted to the vacuum body.
If there is a gap in front,
continue to push firmly until
the Handle is flush.
Insert one screw provided
from the screw packet into
the existing hole. Tighten
securely with a Philliphs
head screwdriver.
1-1
1-2
Position the Hose
Assembly on the
back of the
vacuum as shown.
Attach the Hose
with the remaining
two screws from
the packet.
Tighten securely
with a screwdriver.
Grasping the Quick
Reach Handle, slide the
end of the Hose Wand
onto the Hose Wand
Base. Snap the Hose
into the Hose Clip.
NOTE: The Powerfoot
will not operate
effectively unless the
Hose Wand is firmly
attached.
Slide the
Extension
Wand and
the Crevice
Tool together
into the
storage clip
as shown.
Slide the Dusting Brush Tool into
the storage clip as shown.
1-3
1-4
1-5
Step 1. Attaching the Handle
Step 2. Attaching the Hose and Tools
WARNING!
OPERATE THE VACUUM CLEANER ONLY AT THE VOLTAGE SPECIFIED ON THE NAMEPLATE.
1. How to put it together.
Assembled Vacuum Cleaner Parts
