118
10. Check the amount of supplied water to the ice maker.
1) Remove the upper ice maker
frome the refrigerator.
The Method to control the amount of water supply to the ice maker
1. Disassemble the PCB panel at the top of he refrigerator.
3. If S/W control is completed, check the amount of supplied water to the
Ice Maker.
4. If the amount of water supply is not enough, reset the S/W.
(Read item 2 and 3). If the setting is completed in accordance with water
pressure in the pipe, reassemble the PCB panel.
2. Using the water controlling S/W, control the amount of water supply.
Option to control water-supply time
2) When the test button is pressed, the ice cube container is tured and then water is
out from the tap of the ice maker where water is wupplied. At this time, check the
amount of water.(see the picture)
If there is over-supply of water, the ice cube will be made in attached form of 2 to
4 ice cubes, If there is less-supply of water, the ice cube will be made in small size.
When this happens, you may encounter inconvenience while using. This is not a
problem in the refrigerator. It is the problem of water pressure in the water pipe
and occurs frequrently. When this problem occurs, control the amount of water
supply by the following method.
S/W1
OFF
ON
OFF
ON
OFF
ON
OFF
ON
S/W2
OFF
OFF
ON
ON
OFF
OFF
ON
ON
S/W3
OFF
OFF
OFF
OFF
ON
ON
ON
ON
SR-S24FTA
6 Seconds
5 Seconds
7 Seconds
8 Seconds
9 Seconds
12 Seconds
15 Seconds
23 Seconds
SWITCH NO
MODEL NAME
After change of the water-supply time, the
power switch of the refrigerator must be
turned off and then turned on again.
(Otherwise, the change will not work.)
When the refrigerator is marketed, the
water-supply time is set to 6 seconds.
The amount of water supply depends upon
the set time and the water pressure(water
pressure for home use).
If th ice cube is small, it may be caused by
less supply of water. So, increase the water-
supply time(for example : change the time
from 6 seconds to 7 seconds).
If ice cubes are attached each other because
of over-supply of water, decrease the
water-supply time(for example : change the
time from 6 seconds to 5 seconds).
If the controlled amount of water supply is slightly below
the optimum level, it doesnÕt matter for use.
Notice
When setting the amount of water supply,
do not select the large amount of water
supply from the beginning. Set step-by-step.
(Water can be over flowed)