68
13-2) Disassembly of Evaporator of Freezer
1. After disassembly of the lamp cover for the
freezer, disconnect wire housing from the
lamp socket.
2. Disassemble and remove two cap-screws
using(-) driver or the likes.
3. While holding the bottom of the EVAP-
COVER FRONT and drawing it carefully
toward the arrow direction, disassemble
the cover by sliding it out at the raised
spot.( Since the housing for the thermal-
sensor is located at the rear side of the
cover, be careful during disassembly and
disconnect the housing.)
4. After disassembly of the EVAP-COVER
REAR, disassemble the motor and heater
housing from the wire terminal at the top
side of the cover.
5. After removing two screws of the COVER-
EVAP REAR, disassemble it by pulling it
out to the front using(-) driver or the likes.
( Slide the cover out by pushing the held
part toward the arrow direction and
drawing it to the front )
13-3) Disassembly of Evaporator of Refrigerator
1. Remove all foods in the refrigerator and
shelves.
Disassemble two purifier covers using(-)
driver or the likes and remove a screw.
2. Detach snaps of the bottom side of the
COVER-EVAP FRONT by inserting(-)
driver into the snaps and rotating it toward
the arrow direction.
After detachment of the snaps of the EVAP-
COVER FRONT, disassemble the cover by
pulling it to the front.
3. After detachment of the insulating material,
remove screw of damper cover and
disassemble by pulling it to the front.
( While disassembling the damper cover,
at first disassemble the sensor housing at
the left top.)
4. Disassemble the COVER-EVAP REAR by
deatching the snaps and pulling it out to
the front using(-) driver or the likes.
( While disassembling the COVER-EVAP
REAR, be careful because motor wire is
connected.)
5. Disassemble the motor and heater housing
from the wire terminal at the top side of the
cover.