NETWORK PTZ CAMERA
User Manual
30
Chapter 3. Installing Camera & Network Setup
Connect the cable to the camera’s rear video output terminal and the installation monitor's
video input terminal.
• The wiring varies depending on your monitor type and peripheral devices; please refer to the user manual for each device.
• Please make sure the monitor and camera are turned off when connecting them.
• As shown in the picture below, set the 75Ω/Hi-Z switch of each device to Hi-Z for the intermediate video receiver and to 75Ω
for the end device.
3.5. Connecting Installing Monitor
• This product is a network camera that transfers video over a network; the video output terminal is
used to set the imaging range of the camera at installation.
• Using the terminal for monitoring purposes may cause problems such as degradation in video
quality.
Caution
A.NO
A.COM
GND
TX
D-
D-
TX
D+
D+
GN
D
GN
D
100M
200M
1.N
O
1.N
C
2.N
O
2.N
C
IN
1
IN
2
IN
3
IN
4
A.NO
A.COM
GND
TX
D-
D-
TX
D+
D+
GND
GND
100M
200M
1.N
O
1.N
C
2.N
O
2.N
C
IN1
IN2
IN3
IN4
37x/30x PTZ Network Camera
SNP-3370TH/3301H
SNP-3370TH/3301H
Monitor
End Device
Intermediate
Video Receiver
