© SAMSUNG Electronics Co., Ltd.
18
Failure 3
When No Call is connected.
Troubleshooting 3
END
END
Check the faulty part by tracing
even the CO connector
Is transmission
impossible while reception is
possible?
Check Pin 3 of the
CODEC(Coder/Decoder)
Is Tx signals output made?
Check signals of HWR
(Pin 6 of the CODEC) and BCLKX
(Pin 9/10 of the CODEC)
Check the faulty part by tracing
till the CO connector
Check Pin 14 of the CODEC
Is reception
Impossible while transmission
is possible?
Are Rx signals supplied?
Check signals of HWX
(Pin 11 of the CODEC) and BCLKX
(Pin 9/10 of the CODEC)
Are both transission and
Reception impossible
Is there any
problem in Pin 3
(Tx)?
Check Tx and Rx signals from Pin
3 and Pin 14 of the corresponding
CODEC
Check Pin 9/10(BCLKX),
Pin 5/12(FS), Pin 6(HWR) and
Pin 11(HWX) of the CODEC
Yes
Yes
Yes
Yes
Yes
No
No
Yes
No
No
No
OK
No Call is connected
Is there any
problem in Pin 14
(Rx)?
Check Pin 9/10(BCLKX),
Pin 5/12(FS), Pin 6(HWR) and
Pin 11(HWX) of the CODEC
- Check the point where the signal
occurs or disappears between
Pin 3/14 of the CODEC and the
connector
- Repair the point
Yes
No
END
Содержание OfficeServ 12
