16
Step-by-step installation guide
To use toggle bolts:
Wall
Toggle Wings
Toggle
Bolt
Bolt End
Spacing for Toggles More
Than Wall Thickness
Mounting
Plate
Spacing for Toggles More
Than Wall Thickness
Bolt End
Mounting
Plate
Toggle
Bolt
Wall
Toggle Wings
3
. Place the mounting plate against the wall and insert
the toggle wings into the holes in the wall to mount
the plate.
NOTE
: Before tightening the toggle bolts and wood
screw, make sure the bottom of the Mounting plate
runs along the bottom Horizontal line of the “Rear wall
Template” and the Mounting plate is properly centered
under the cabinet.
CAUTION
: Be careful to avoid pinching your fingers
between the back of the mounting plate and the wall.
4
. Tighten all bolts. Pull the plate away from the wall to
help tighten the bolts. Tighten the screw.
C. USE THE TOP CABINET TEMPLATE
TO PREPARE THE TOP CABINET
You need to drill holes for the top support screws and a
hole large enough for the power cord to fit through.
• Read the instructions on the TOP CABINET
TEMPLATE.
• Tape it underneath the top cabinet.
• Drill the holes, following the instructions on the TOP
CABINET TEMPLATE.
CAUTION
: Wear safety goggles when drilling holes in
the cabinet bottom.
D. MOUNT THE MICROWAVE OVEN
FOR EASIER INSTALLATION AND PERSONAL SAFETY,
WE RECOMMEND THAT TWO PEOPLE INSTALL THIS
MICROWAVE OVEN.
IMPORTANT: Do not grip or use the handle during
installation.
NOTE
: If your cabinet is metal, use the nylon grommet in
the power cord hole to prevent the cord from being cut.
NOTE
: Filler blocks are required when mounting this
unit under any cabinet with a recessed bottom or front
overhang. (See page 9.)
IMPORTANT: The case damage that will occur
from over tightening screws if you do not use filler
blocks is not covered under warranty.
IMPORTANT: For models with the grease filter
installed, don’t push up on the filter when you
mount the oven.
Grease Filter
Grease Filter
Grease Filter
Grease Filter
NOTE
: When mounting the microwave oven, thread
the power cord through hole in the bottom of the top
cabinet. Keep it tight throughout Steps 1–3. Do not
pinch the cord or lift the oven by pulling cord.
SMH1927_XAC_DE68-04108B-06_EN+CFR.indb 16
SMH1927_XAC_DE68-04108B-06_EN+CFR.indb 16
2022-01-20 �� 10:19:11
2022-01-20 �� 10:19:11