10
Step-by-step installation guide
D. ALIGNING THE WALL PLATE
CL
CAUTION:
Wear gloves to avoid cutting
fingers on sharp edges.
Area E
Hole B
Hole A
Centerline
notches
Draw a Vertical Line
on Wall from Center
of Top Cabinet
Draw a Horizontal line on wall from
bottom of “Rear Wall Template”.
Horizontal Line
Horizontal Line
Draw a Horizontal line on wall from
bottom of “Rear Wall Template”.
Draw a Horizontal line
on the wall along
the bottom of
“Rear Wall Template”.
Horizontal Line
Horizontal Line
Area E
Centerline
notches
Hole A
Hole B
CAUTION
: Wear gloves to avoid cutting fingers on
sharp edges.
1
. Draw a Horizontal line on the wall at the bottom
of the “Rear Wall Template”.
2
. Drill ⅝˝ holes for toggle bolts in 3 locations
(Hole A, Hole B, Hole C) as shown in the
illustration above. If the location of a hole lines up
with a stud, drill a
3
/
16
˝ hole for a wood screw.
You cannot use a toggle bolt to attach the wall
plate to a stud.
NOTE: DO NOT MOUNT THE PLATE AT THIS
TIME.
3
. Holes A, B and C are inside area E. If none of
these holes line up with a stud, find a stud in area
E that lines up with a hole circle in Area E, and
then drill a
3
/
16
˝ hole into it for a wood screw. You
must have at least one wood screw mounted
firmly into a stud to support the weight of the
microwave.
Set the mounting plate aside.
SMH1927_XAC_DE68-04108B-06_EN+CFR.indb 10
SMH1927_XAC_DE68-04108B-06_EN+CFR.indb 10
2022-01-20 �� 10:19:09
2022-01-20 �� 10:19:09
