20
PROGRAM PERSONAL SPEED DIAL
NUMBERS FOR OTHER STATIONS
Individual station users can program their own numbers, but in cases where
this is not practical, or for single line telephone users, this program allows a
system administrator to view or change any station’s speed dial numbers.
The station speed dial codes are 00–49. Each station begins with ten num-
bers (00–09) and can be assigned more in blocks of ten (up to a maximum
of fifty numbers).
Each speed dial number consists of a line access code and the telephone
number to be dialed. The access code can be any line group, individual line,
station group or individual extension. The speed dial number can be up to
24 characters long including
4
,
#
,
FLASH
and
PAUSE
.
NOTE: If Least Cost Routing (LCR) is used, the LCR access code must be
entered.
When you are entering a speed dial number, there are some special keys
that you will need to use. These are the bottom six programmable keys on
the right hand side of the DS 24D keyset. These keys are known as
A
,
B
,
C
,
D
,
E
, and
F
(see the DS 24D Keyset User Guide, Dialing Features)
.
PROGRAM KEYS
UP
&
DOWN
- Scrolls through extension numbers and speed dial bins.
KEYPAD
- Used to enter number.
Hold
- Press to clear entry.
A
- Does not have a function.
B
- Inserts a FLASH.
C
- Inserts a PAUSE.
D
- Changes the dialing type from pulse to tone.
E
- Hides and displays digits.
F
- Enters the speed dial name.
iDCS_16sys_adm.qxd 12/14/2004 4:27 PM Page 25
21
Open customer programming and follow the instructions below.
ACTION
DISPLAY
1. Press
Transfer
and then dial
105
[201] SPEED DIAL
Display shows
00 :
2. Dial the station number (e.g.,
205
) OR
[205] SPEED DIAL
press
UP
or
DOWN
to select the station
00 :
and press the right soft key to move the
cursor OR press the left soft key to go
to step 4
3. If the selected station has no speed dial
[205] SPEED DIAL
bins, this display will be shown and a new
NO SPEED BLOCK
station may be selected
4. Dial the location number (e.g.,
05
) OR
[205] SPEED DIAL
press
UP
or
DOWN
to select the location
05: _
and press the right soft key to move the
cursor OR press the left soft key to return
to step 2
5. Enter the trunk access code (e.g.,
9
)
[205] SPEED DIAL
followed by the number to be dialed
05 : 9-4264100_
(e.g.,
4264100
) OR press the right
soft key to return to step 2 OR press the
left soft key to return to step 3 OR press
Hold
to clear an entry (if an error is made,
use the
DOWN
key to step back)
6. Press the
F
key to access
Program Station
Speed Dial Names
OR press
Transfer
to save
and exit programming OR press
Speaker
to save
and advance to the next program
DEFAULT DATA: NO SPEED DIAL NUMBERS PROGRAMMED
iDCS_16sys_adm.qxd 12/14/2004 4:27 PM Page 26
