ENG - 13
2.
Press and hold
ID SET
on the rear of the subwoofer for at least 5 seconds.
• The red indicator on the rear of the subwoofer turns off and the blue indicator blinks.
5 Sec
Blinking
blue fast
Rear of Subwoofer
Rear of Subwoofer
3.
Press the
Up
button on the remote control for 5 seconds.
• The
ID SET
message appears on the display of the Soundbar for a moment, and then it disappears.
• The Soundbar will automatically power on when
ID SET
is complete.
SOUN
D
MOD
E
PAIR
5 Sec
ID SET
4.
Check if the LINK LED is solid blue (connection complete).
Blue is On
The LINK LED indicator stops blinking and glows a solid blue when a connection
is established between the Soundbar and the Wireless Subwoofer.
LED Indicator Lights on the Rear of Subwoofer
LED
Status
Description
Resolution
Blue
On
Successfully connected
(normal operation)
-
Blinking
Recovering the connection
Check if the power cable attached to the main Soundbar
unit is connected properly or wait about 5 minutes.
If blinking persists, try manually connecting the
subwoofer. See page 12.
Red
On
Standby (with the
Soundbar main unit turned
off)
Check if the power cable attached to the main Soundbar
unit is connected properly.
Connection failed
Connect again. See the instructions for manual
connection on page 12.
Red and blue
Blinking
Malfunction
See the contact information for the Samsung Service
Centre in this manual.
NOTE
• If the main unit is powered off, the wireless subwoofer will go into stand-by mode and the STANDBY LED on the rear of the sub-woofer will
turn red after blinking in blue several times.
• If you use a device that uses the same frequency as the Soundbar near the Soundbar, interference may cause some sound interruption.
