Installation
English
25
STEP 3
Connect the electrical wiring
” section, and follow these steps.
3-wire system
A.
External ground connector
B.
Neutral grounding wire (white)
C.
Center silver-colored terminal block
screw
D.
Neutral wire (white or center wire)
E.
3
/
4
” (1.9 cm) UL-listed strain relief
1.
Loosen or remove the screws from the
center terminal block.
2.
Connect the neutral wire (white or
center wire) of the power cable to the
center, silver-colored terminal screw of
the terminal block. Tighten the screws.
3.
Connect the other wires to outer
terminal block screws. Tighten the
screws.
4.
Tighten the strain relief screws.
5.
Insert the terminal block cover into the
rear panel of the dryer. Then, secure the
cover with a hold-down screw.
CAUTION
• To convert from the 4-wire system
to 3-wire system, connect the ground
strap to the terminal block support to
ground the dryer frame to the neutral
conductor.
• Ring-type terminals are recommended.
If using strap terminals, make sure they
are tightened.
• Before Installing the Dryer, confirm
240V is present between L1 and L2 at
the power receptacle. If the Voltage is
low, it may not dry properly. Review
the “
if needed.
DV3200T_DC68-03784N-00_EN.indd 25
2020-05-25 11:10:20
B
C L2
L1
D
E
A
Содержание DVE45T3200 Series
Страница 1: ...Dryer User manual DVE G 45T3200 DV3200T_DC68 03784N 00_EN indd 1 2020 05 25 11 10 17 ...
Страница 57: ...Sèche linge Manuel d utilisation DVE G 45T3200 DV3200T_DC68 03784N 00_CFR indd 1 2020 05 25 11 29 05 ...
Страница 113: ...Secadora Manual del usuario DVE G 45T3200 DV3200T_DC68 03784N 00_MES indd 1 2020 05 25 11 10 48 ...